2043 search results for need replacement motor
OK
Ad
  • Need replacement motor.... - Forum

    Need replacement motor..... Archived from groups: rec.audio.tech () The capstan drive motor in my Yamaha K-700 has started squealing, which a bit of lube wont fix. The original motor is a Sankyo BFA2L38 31121-A. Yamaha will sell me a replacement for $75...

  • Consumer Turntable Question - Forum

    base in really terrific condition. It's equipped with a model 120 tone arm and a pickering V-15 Micro IV ATE cartridge. The styli on both tables need to be replaced (waiting for Needle Doctor delivery) and I'm watching both tables spinning now (I need a...

  • Rega Planar 3 drive Problem - Forum

    I would be grateful for any advice on reviving it - if I must, I will buy the rega motor upgrade but with Christmas coming , I would prefer a cheaper option. I have replace the motor itself which has not fixed the problem so I have turned my attention...

  • Need Motor For Kenwood KD-500 Table - Forum

    Need Motor For Kenwood KD-500 Table. Archived from groups: rec.audio.tech () I have a Kenwood KD-500 direct drive table w/ a dead motor. Anyone know of a source for the motor? The label on the motor reads: DC 18V 33-1/2, 45 rpm Model MKX-15F Matsushita...

  • Linn Upgrade or Not - Forum

    the belt is tight enough, and there is > sufficient oil in the bearing well? My original LP-12 developed a failed > on/off switch and a dead motor. Did you ever have to go in and under the > table to replace the motor? I had to, and restoring all to its...

  • Replacement motor for Linn Axis? - Forum

    Replacement motor for Linn Axis?. Archived from groups: rec.audio.tech () I want to go through the motor control board of my Linn Axis (replace old caps etc) and at the same time perhaps change the Airpax/Philips motor. The shaft/rotor is very slightly skewed...

  • Leslie custom speed control help? - Forum

    to >achieve reduced speeds from a single speed motor." >>Sounds like an SCR to me. Probably not an SCR. SCR controllers (usually) provide half wave rectified pulsed power. >"CONNECTING AN OSCILLOSCOPE TO THE OUTPUT OF THE HAMPTON MOTOR CONTROL >WILL...

  • Parts And Materials - Reviews

    sake in this build we will replace the existing main drive motor in the printer. The reasoning behind this is the original motor is a stepped motor and it would take longer, and cost more in parts, to build a controller for it than it would to replace the motor...

  • Cassette Deck Recommendations? - Forum

    It will be used partly to get some cassettes that I have onto my hard drive (those that can't be replaced or that I want to keep but not spend money replacing) and partly for playing cassettes; at a later date, I may press it into service in a home studio...

  • installing hardware - Forum

    installing hardware. For safety reasons, do I need to remove all power supply connections to other peripherals when installing a card in one of my PCI expansion slots?. For safety reasons, do I need to remove all power supply connections to other peripherals...

Ad