with "route print", then adding the route with specifying the interface of the WAN (PPP/SLIP) Interface works fine and we have the functionality we need. The route we want is successfully added as the printscreens from the command prompt below shows. Unfortunately,...

I can also SEE the 10.10.x.x network, but when i try to access any of the servers or pc's, i get errors. I am guessing that i may need a Route put in so the traffic knows where to go. Hopefully i explained this clear enough, if not, let me know. Thank...

setup in my office via XO but need some help configuring the routing of this via my sonicwall running SonicOS enhanced firmware 5.2. XO provided us with one WAN IP to setup and a block of 28 LAN IP's that need to route through the WAN IP to be public. Wan:...

Case Log] Project Sestren Worklog -World's First Back/Outside Mounted. - a PC1X1 project - ...

where I need to route the S/PDIF output of a > Meridian preamp/processor to one of two different destinations. Can't > go to both simultaneously, so a DA won't work; has to select between > Output A and Output B. >> Also need to be able to switch between...

where? Do I need to bridge the two adapters in the Win2K3 box? Given the above scenario, what routing has to take place to allow the remote machines to log in to the LAN and browse the domain? I read there was a need for a WINS server? I wll try that...

incoming traffic request is being implementing by an entity/characteristic of the router different than NAT. And i beleive that this is actually the job of a firewall. Correct me if iam wrong but i think we need to seperate in a clear way these 2 consepts...

you're on and point it to Sify's router. Something like: route add 10.0.0.0 mask 255.0.0.0 10.40.183.1 This sets up your Internet like normal, and tells your computer than any traffic destined for 10.x.x.x needs to be routed through...

there's a routing table, what is in it? (I will speculate) > No need to speculate. Here's a sample routing table from a Linksys broadband router made circa 2000. Destination LAN IP Subnet Mask Default Gateway Hop Count Interface...

Forwarding Ports from Modem to Router. I'm trying to host games in Warcraft 3 and need port 6112. I have; DSL 2 computers runnning WINXP service pack 1 Efficient Speedstream 5667 dsl modem Linksys BEFSR41 v2 router I need access to port 6112. Both...