Need help setting up router. Archived from groups: alt.sys.pc-clone.dell () OK, folks, I guess I got overconfident as installing the extra memory in my Dim 2400 was such a breeze. Anyway, current situation: I ordered a Dell Inspiron notebook with an internal...

I've never tried anything like this. When I start a server, no computers on the other side of the router (on the Internet) can see the server. If someone can even just point me in the right direction to figure out how I need to set the router up, I would...

it sounds like you have d-link router and card adapter. If this isn't your speed, update the firmware and drivers. Do you mean the room with the worst signal? Try setting up everything with the router and adapter in the same room first, then test range....

your 2nd router as static IP, you will need to set static IP info as mentioned early in all pc connected to router 2. If your router as a mode known as Classic routing, it will pass the info up to router 1 and let it set the Connection Info. I sent you the...

even need the 2nd router in that situation. So on to the questions. 1) Can I even do this? Is it possible to hook a router up with a cable running from a wire? 2) Why isn't it working!? Do I need to set up a new network or something like that?...

subnet (255.255.255.0). Then you would need to set up DNS within your router to first point to your server, then to your ISP's DNS. Now, you're working with a Domain and a workgroup. You'll need to register your workgroup computers in DNS by joining the...

a record of the custom router settings you have made, so it's easy to recover from a router reset. >Anyone have any ideas? What I did, was first increase the "DHCP lease time" (that's a router setting). Even better, enable "static DHCP" (see the other...

doing this on a Mac are rather shabby), I got rtvpatch to run. It said everything was good. I plugged the new disk into the RTV. RTV booted without a problem. But now when I try to do anything, it complains that I need to activate it. If I go to the...

a record of the custom router settings you have made, so it's easy to recover from a router reset. >Anyone have any ideas? What I did, was first increase the "DHCP lease time" (that's a router setting). Even better, enable "static DHCP" (see the other...

doing this on a Mac are rather shabby), I got rtvpatch to run. It said everything was good. I plugged the new disk into the RTV. RTV booted without a problem. But now when I try to do anything, it complains that I need to activate it. If I go to the...