FS Parts for Dyna Dynaco and Manual/Schematics. Archived from groups: rec.audio.pro () FS Parts for Dyna Dynaco and Manual/Schematics We are parting out the following Dynaco pieces Need something? knobs, meters, faceplates, power supplies, transformers,...

FS Parts for Dyna Dynaco and Manual/Schematics. Archived from groups: rec.audio.tech () FS Parts for Dyna Dynaco and Manual/Schematics We are parting out the following Dynaco pieces Need something? knobs, meters, faceplates, power supplies, transformers,...

Dynaco 400 Power Amp. Archived from groups: rec.audio.tech () I just purchased a used Dyna 400 and need some help. I don't have a parts list or even a schematic. So, my problems are compounded. But here goes. There is a small circuitboard mounted on...

Caps" thread. I too have a Soundcraft 200 series console waiting to be gone through. (A reasonable beast to work on; lots of room on the boards and Harmon was good about emailing the schematics.) My plan has been to replace the TLO7x chips with better...

Pro amps vs. consumer amps. Archived from groups: rec.audio.high-end () How do they compare? This question arises because a customer of mine asked me about one of his amps, made by Crown. All he could tell me is that it cost about $500 and has a rated...

FS Power Amp Parts Crown, Dyna, Mackie, Phase, Cerwin, QSC. Archived from groups: rec.audio.pro () FS Power Amp Parts Crown, Dyna, Mackie, Phase, Cerwin, QSC We are parting out the following amps need anything? Altec 1590, 1590C Cerwin Vega A1800 Crown...

FS Power Amp Parts Crown, Dyna, Mackie, Phase, Cerwin, QSC. Archived from groups: rec.audio.tech () FS Power Amp Parts Crown, Dyna, Mackie, Phase, Cerwin, QSC We are parting out the following amps need anything? Altec 1590, 1590C Cerwin Vega A1800...

you probably don't actually have LS3/5a's there, because the spec requires selected drivers, but ignoring that...see if you can get a clean Dynaco Stereo 70. They pair up surprisingly well with the LS3/5a's, especially if you drive from the 4-ohm tap, and...

Dynaco Mark II's, 6550 tubes possible?. Archived from groups: rec.audio.tech () Is it possible to use 6550 tubes in Dynaco Mark II amps? These were originally made for EL 34 tubes, but someone told me that if the bias was changed to 1.92 mv, 6550 tubes work...