28391 search results for powers post
OK
Ad
  • System powers up, but no post - Forum

    System powers up, but no post. Hello - I just built a new system with an AMD Phenom 2 X3, , and . The system powers on, yet I get no post. CPU fan is running, double/triple checked the memory, graphics card (9400 GT), etc. Does it sound like the mobo is...

  • MSI X58 - powers but will not post - Forum

    MSI X58 - powers but will not post. New: Zalman 600 PS, I7 920, MSI X58 Pro, MSI 260 GTX, WD 1TB SATA, OCZ DDR3 2GBx3 (a triple channel pack) Old: generic 2 - IDE DVD's and a LianLi case (the 5th suystem in this case ... I sure do like working with it) The...

  • Powers on but does not post - Forum

    both of the hard drives spin up, but no post. After about 30 seconds of sitting there, the PC will power itself off, pause 3 seconds, then power itself back on, after about 15 seconds it may post and go into windows or it may continue to wait, then power itself...

  • Asus PP-DLW Power On But No POST and NO Video - Post Code 2A - Solved - Forum

    Asus PP-DLW Power On But No POST and NO Video - Post Code 2A - Solved. Hello, I have an Asus PP-DLW motherboard that powers on but I cannot get it to post. The complete system consists of the following: • Asus PP-DLW Revision 1.03 Motherboard • Kingston...

  • XFX nForce 680i LT - No Posts no display no bootup. - Forum

    has the blue light on and everything powers on, i think it's between the CPU and the graphics card.... what graphics card do you have ? I just built my rig based on that same mobo and powered on and POST on the first power on. You don't have to adjust any jumper...

  • E-Machine Am37-L motherboard wont post,boot - Forum

    E-Machine Am37-L motherboard wont post,boot. I have a client with a Am37-l motherboard , Athalonxp 2600 processor. The power supply was bad so i replaced it. But now the motherborad will not boot, no video, no post, everything else seems to run. I reset the...

  • No post with more than one RAM - Forum

    and steps to date. Rig shut down without warning, no power. Restart without successful post, shuts down in 3 seconds. Disconnected ATX12V line, powers on, but no post. Cleared BIOS, nothing. Stripped to the bones, MB, PSU, (1) 2GB RAM of (4) 2GB RAM...

  • SN41G2 strange power up behaviour - Forum

    of the memory, so I'm thinking it's : going out - but I'm not getting any POST errors. I'm planning on swapping : out the memory. If it fixes the problem, I'll report back. The green LED you reference simply means the board is getting power from the...

  • New Build Won't Post, Won't Boot (And I went through the guide, even) - Forum

    to power up, but no boot. A little better investigating revealed that CPU wasn't compatible with the board, so I swapped it for the 9600, which is supported. Still, the board powers up, but no post beep, no warning beep, no nothing. I've even exchanged the...

  • X38-DQ6 boot cycle - Forum

    not POST at all and no video is initialized either! The total hardware is: Q6600 CPU Gigabyte X38-DQ6 motherboard G.Skill PC2-8000 2Gb (x2) Radeon 1900XT WD RE2 500Gb HDD Enermax Liberty 650w PSU everything is using stock settings but the system only powers...

Ad