I also got some spaces to remount my radiator so it is not so close to the p/s exhaust. Anyways been searching forums for an answer to this question and figured I should just ask here. I bought another radiator and some fans and was planning on mounting it...

variable, under these conditions, would then be the speed of the fan on your radiator, just as an increase in a car's speed necessarily results in an increase in the velocity of cooler air entering the car's radiator, causing that radiator to exhaust...

warm air through the radiator though, eh? My Antec SOLO case has washable air filters on the intake fans and they come in VERY handy. I can't say that I'd be too keen to put a radiator in my case intakes -OR- having a radiator behind dirty air filters....

this is why I went with the expensive Noctua fans. I would like some input on a good fan controller to use. I don't need anything super fancy, but I would like something that I can just trottle down my radiator fans while playing media, etc... You should...

1/2" so it should suffice. The radiator is going to be a recycled heater core from an automobile, the one I am looking at is about 7"x7" and it will fit into the top of my case quite nicely (since I have a Full tower case). I have four 120mm fans from an old...

performance drastically better if you increase the air flow above 80 or 100 cfm. So, if you have a low air flow radiator, get fans that are quiet, push a decent amount of air and have good air pressure. Other important information/Tips 1) If the radiator...

radiator (on the outside of the rear panel wall). My only question here is how do I get the processor fan control to control BOTH radiator fans... or is one of the fans left to run continuous. Alternatively, the Corsair H50 seems ideally small and simple other...

chip Active cooling (air): 3 fans inside PSUs 2 HD fans 6 casefans (bottom 92mm, left side 80mm, top 80mm, rear 60mm, 2*front 80 and 40mm) temp controlled by DigiDoc5 1 PCI slot fan (40mm) 1 120mm Delta HP radiator fan controlled with some resistors...

general P5Q thread with an emphasis on overclocking. I'd like to see people reply with overclocking suggestions, also other peoples experiences with this board. As for the motherboard I've been an Abit fan for years until they slipped and put themselves...

a second supply of coolant to fill the kit with. 2) The radiator lies matched up with the exhaust fan on the back of my case. Is pushing hot air into the radiator something I want to be doing? Should I be removing that exhaust fan? 3) How important...