Now however, device manager is mis-recognising it as an AXV CD/DVD ROM SCSI cd rom device and so, naturally, it won't record. It will also not read the DVDs I have backed up onro. I have tried uninstalling it in device manager and scanning for hardware...

Cd Rom Device Not Ready. Device not ready. Device not accessible. I connected a cd rom drive to my computer so that I could install software for an external hard drive. The cd rom light goes on during boot but when I attempt to use it I get the above message....

problems. I checked the drivers they had loaded from the Device Manager, copied them onto a floppy and copied them onto my HDD exactly where they were on the other computer. They overwrote the same driver files I had on my computer. Still no go. Device Managers...

from groups: microsoft.public.windowsxp.help_and_support () Installed new cd rom still doesn't work. In device manager its says for both cd rom devices ( Windows cannot load the device driver for this hardware. The driver may be corrupted or missing....

a sony vaio p505 with a docking station. All of a sudden, In my computer it doesn't show the cd drive. I went to device manager and there is an exclamation mark by the cd rom. The device status says code 10. Its a cd burner. any suggestions would be...

CD ROM is like wise probably not being seen again in Device manager look and see what the conflict is. Or go into the BIOS and make sure the AUTO DETECT is on for the CD ROM and other devices. I let the system assign the resources via the AUTO settings. Also...

a CD into the drive, it shows some light at the drive front then off. Interestingly, when I check Device Manager, the item CD/DVD Rom Drive shows VX3210Q XSQ895U SCSI CD ROM Device instead of Matshita DVD RAM UJ-850S ATA Device. Also it says this device is...

Device Manager and look under atapi devices. The second listed Primary IDE controller shows that the first device, the hard drive is useing DMA mode 5 and the second device, the cddvd burner is useing PIO Mode, even though it says use DMA if available....

runing my CD-RW on SEC IDE Master and my CD-ROM as a slave on the same IDE with no problems Now. knock on wood. I lost my cdrw and rom in device manager. and as it was suggested I removed my controller (IDE) and rebooted then rebooted all was well seems there...

alt.sys.pc-clone.dell () I think you might need to enable cd audio for the cd rom. Find the cd rom in device manager and tick the `enable CD digital audio for this cd rom device` box on its properties sheet. Hope that works. B wrote in message...