Router vs. AP - Bridge mode (point to point, multipoint) -... Archived from groups: alt.internet.wireless () Hi, Two quickies: First, I was wondering if anyone knew of a good site (I have yet to find one) that deals with repeater vs. bridging modes and...

Dlink 2100AP bridge mode setup question. Archived from groups: alt.internet.wireless () Hi All, I have 2 x Dlink 2100Ap which I have setup as bridge mode. Wireless link is always up, no problem there but internet on the remote computer works for 3-4 mins...

bridge" mode. Most of these can handle up to 30 MAC addresses at a time. However, the WAP11 also includes a client mode and an access point mode. These are also bridges but they work differently. In client mode, the ethernet to wireless bridge is...

combo's are strictly AP's. Traditionally and predominately anyway. Most SOHO AP's can act as a point to point or point to multipoint bridge, a workgroup bridge (client mode), and a few can even act as repeaters now. If you have a NAT router in place then...

access point. I'm not sure exactly how they do this, so I won't try to guess. Bridges can come in point to multipoint, which really should be called a "wireless switch" but that might cause consumer confusion. This point to multipoint wireless bridge...

that it will act as a workgroup bridge, though I would be almost certain the Linksys devices do both. A bridge, in the strict since will only talk to other Bridges, point to point or point to multipoint. A workgroup bridge, or AP in client mode, will associate...

client adapter card. Some access points can do bridging but this is becoming less common as manufactures can charge more for a bridge. Wireless bridges, bridge networks and work in a point to point or point to multipoint configuration. They usually...

to multipoint mode there and use bridges for the two cameras. Sorry FredWeston is that better Regards John One AP at the mast, one at each camera, one at the office. The one on the mast will be point to multipoint, all others will be point to point....

said that you may want to set up the network in a Point to Multi-Point mode (page 25 of on-line manual) No, you don't want to bridge. That is what point to multipoint would do for you. Basic, non WDS repeating is what you want but sounds like what your already...

access points in point to point bridging mode one master and one slave to link two LAN segments, they can not talk to normal clients in this mode so you will still need access point(s) for your client pc's. there are also other modes available eg Point...