to "OnBoard SATA". A SiliconImage screen will appear immediately after the normal POST showing the Raptor model number as being detected. After getting the drive detected, I used the SATA controller driver disk with Windows Setup to install Windows and...

LT SLI motherboard in it. But when i try to install XP 64, it says no Hard drive detected. I have a WD raptor in SATA. I have read that my motherboard can't read sata drives so it can't detect the drive. I have been trying to use this guide to slipstream...

Controllers Windows treats all mass storage controllers the same way. Whether it's a standard IDE controller, SATA controller, SCSI controller, or RAID controller, Windows has to have a driver for it in order to use it. Once Windows has a driver installed...

Channel, some SATA, and most proprietary controllers. AHCI does not require any particular feature set or feature support from the hard drive. Any SATA drive can be installed on an AHCI controller - whether it implements SATA150 or SATA300, implements NCQ...

for an SATA controller at my nearest Compusa..unfortuntily none was avalible :( So not until i went to NYC last week where I found a COMPUSA SATA controller. I installed it last night when I got back from NYC loaded the drivers and it worked fine under XPHome..but...

etc. SATA controller driver Your Motherboard or SATA controller card requires a driver to work properly. If you did not get a Floppy Disk with the SATA driver included with your Motherboard you will have to make one. The SATA drivers can be located on...

I have only one hard drives, and it's SATA. The SATA controller drivers have to be loaded when you're installing Windows, otherwise it won't recognise the drive. Barton 2500+, 512MB Corsair Platinum XMS 3200 CL2, Radeon 9700, WD Raptor 10,000 rpm S-ATA...

sata controller are loaded otherwise I wouldn't think it would be able to see the drives. Thanks for any help. Set one of them up for the install and then RAID them afterwards. The drivers for the controller should get good if the setup detects them from the...

Peripherals, take the first choice, IDE Function Setup, and from that the second-last choice, S-ATA Controller. Make sure at least the SATA ports you are trying to use (and maybe all of them) are Enabled. Quick check for that: you also have a SATA-connected...