ICHxR's, it supports six SATA ports - the other two (different colored - likely purple) are on the Jmicron - that's, lemme count now - umm - [strike]ten[/strike]eight ports total... The "** This version supports only Hard Disk and CDROM drives ** Please...

The P6T has: A) 6 X SATA 3GB/s ICH10R Southbridge ports which (using Intel Matrix Storage) supports SATA RAID 0,1,5,10. B) Plus it has the JMicron JMB322 2 X SATA 3 GB/s Obviously the SATA RAID has to go onto the ICH10R Southbridge ports. However, multiple...

Transfer mode for my HDD's is SATA Gen 2-3G. That is what I was getting at. The SATA ports on the board are SATA II, which IS supporting the opticals. why would there be issues with burners on SATA 1 in the first place? SATA 1 is a faster than IDE It's...

So really I'd be needing 8 SATA ports - SSD for OS, 6x drives in RAID, and blu-ray. I couldn't find any current generation integrated controllers that support SATA port multipliers (the next gen SB810 and SB850 may support them), thus the need for a PCIe SATA...

can set them up bij booting beyond the actual bios and then press a key to config de Jmicron controller. The intel controller only supports the sata ports and they are shown in your bios. one sata and the ide is controlled by the Jmicron and should be set...

recommend a sata controler card? It does not have to have raid 5, but atleast 4 ports. Unless the Celeron D is not enough CPU power to do a software raid 5. I doubt that it will make a difference if I use SATA 1.5Gb or SATA 3.0Gb because over the network, with...

not here yet; might be called SATA 6) = 6Gbit/sec Check wikipedia for more info than you care to know about sata So for example, my sata ports on my motherboard can support up to 3gib/sec transfer speeds, which qualifies them as being sata...

limits on how many SATA ports. For example, if your board has 4 SATA ports controlled by the main chipset, plus 2 or 4 more SATA ports controlled by another extra chip, you could have a problem. Putting the boot drive on SATA0 port leaves only 3 more SATA ports...

card instead of onboard. Current (main comp) has: Sata port 1 - WD Raptor 74GB Sata port 2 - Seagate Barracuda 500GB Sata port 3 - WD Raptor 74GB Sata port 4 - Seagate Barracuda 500GB The motherboard has 6 Sata ports, but the first 4 are controlled by its...