do load balancing without fast etherchannel enabled. This will depend on the switch and specific cards purchased. 3Com server cards do load balancing. I don't recall the exact model #..... man, your getting expensive! how do you shoot the devil in the...

One Server - Two NICs - Load Balance?. So my server has two 1Gb NICs. Each obviously has a different IP. I would say that one NIC does 90% of the traffic because most systems DNS resolve to the first IP. I know that one use of load balancing is to use multiple...

to use all 4 NICs for load balancing between the 2 servers? I'm going with 2 NICs to load balance. Yes I have 2 servers with 2 gigabit NICs each (at the moment only 1 is used on each server for load balancing). the servers a connected to an 8 port gigabit...

IPs? This is most likely a w2k server only thing (professional doesn't do load balancing, I think). They (the NICs) have to have separate IP addresses to be on the same network. I'm not sure if you can make one send and the other receive, but the load balancing...

Data Transfer speed concern. Hello, Recently I planned to upgrade my 42 users and 8 servers LAN from 10/100 to Gigabit. All Servers have Dual Intel NIC's with load balancing. Desktops are now running d-link 530T Gigabit NIC's. My machine and the Servers...

card. My file server has a 4 disk raid5 on a 64bit 3ware controller (which is in a 64bit slot), 1.7gb of ram, and a 64bit 3com gigabit server nic. My switch is a Netgear GS116 16port gigabit switch. I am currently not using jumbo frames. I could probably...

2 CPU's and load balances between the two CPU's. I also went multi-boot for OS too. Boot 1- XP Pro with mutiple displays for graphic work (RAID 0) Boot 2- XP Pro single display SLI for games (WD Drive Partition1) Boot 3- Windows Server 2003 32bit for server...

Network Load Balancing, which you might be able to use with Windows Server.. it'll install on the server itself. Though, in my position, we have our ISP load balance for us so we don't have to configure it. But you're looking at a high end router.. Cisco...

I just can't figure out how to get both NICs to become configured and balanced. I can see the server and move files with one configure NIC and one misconfigured NIC. Also the server cannot access the internet. Is NLB designed to do this? Everything I read...