if its a straigh-through cable it won't work. You can verify the connection is active if the ports on the router light up when plugged into the switch. If it is a cable issue make sure you get cross-over cable, its used to connect devices with ports that...

Switch from Cable internet to DSL router not working. I switched from charter internet to AT&T DSL and I have had nothing but trouble with the router. I have very little knowledge of how it is supposed to be set up. I did get the the modem set to PPPoE (Bridge)...

consecutive swap of cable modems, although the ISP did not change) the router worked absolutely flawlessly. With this new cable modem (Terayon TJ715), the router has simply ceased to work. I can LAN across it just fine (4-port switch on the back), but if I...

around christmas time etc... so they might've signed up a lot of people in my area, and that is why my cable internet might be slow. So now, instead of buying a new router, I just thought i try switching from cable to DSL. Do you think it is worth it? I'll...

The laptop's default gateway address will route traffic to the router connected to the cable internet, and that router will not have a route back to the 2 PCs connected va ICS To be honest I think you need all your PCs and Laptops on the same network, and...

my friend For your Cable service. Do you have a cable modem then its connected to a router? or do you have a cable modem/router all in one? If you have Just a cable modem, then I'd recommend getting a 8 port switch and plug the cable modem into the uplink...

Cable/DSL router to 10/100 switch issues..eek. Hey everyone. Well, I ended up picking up a LinkSys cable/DSL router. My intent is to hook the Router into my linksys 5 port 10/100 switch. Now, I should say connecting the Cable/DSL router to my PC directly...

ip installed. Plug your cable modem into your internet router and then connect the router to the network cards using cat5 cabling. With netgear the router works as a DHCP server. You might have to configure it a little bit but it's easy. Just open up internet...

You're SOL. You can't use a DSL Modem/Router on a cable system. PPPoE only works on DSL. Get a cheap wired router, Disable DHCP on the Linksys and you can use it as a wireless access point. Grumpy DSL is PPPoA, while cable is usually PPPoE. The cablemodem...

modem ethernet cable into the WAN port on the router. Go into the router and configure PPoE with username and password. Set up a LAN connection to the router on your computer. Make sure that your firewall is not blocking the router internet connection. If...