I7 860 VERY SLOW BOOT and POST! Please HELP. I recently built a new system using the components listed in my signature below. Average system boot time is almost 5 mins with 4 of those mins being after post, during OS load . I have tried reinstaling...

of the 4GB wont let me boot the system I also tried diffrent combinations like old ram with new and results were that as long as its 2GB it will boot but not 4GB :cry: after a lot of googling here are the thing i tried until now: updated bios - nothing...

second dimm, it again would not boot or post. Eventually I was able to get it to boot consistently with the other video card and 1 stick of ram, until I reinstalled the 4890 which left me with no boot or post again. Would the polarity of the start and reset...

You cant boot to a blank drive, you have to boot to the cd the operating system is on. Try the 3 channels that are farthest from the cpu to install your dimms. I've seen this cause system to not boot on X58. okay, i am now able to get into bios but its...

Asus P5K P35 Chipset boot problem!!!. I had recently post a thread couple of days ago but i wasnt sure i get satisfying reply.So here i am asking again if anyone of you have expertised advice for me. 4 nights ago i had completely built the system for my...

SUPER Slow Boot Time. Please Help!. I recently built a new system using the components listed in my signature below. Average system boot time is almost 5 mins with 4 of those mins being after post, during OS load . I have tried reinstaling OS twice....

Cold start P.O.S.T vs. Warm Start P.O.S.T.. Hey All, I'm new to forums but need help. I have ABIT VT6X4 MB, Crucial PC133 (2 X 256), Pentium !!! 800, WINXP Pro. System will not boot from cold start (power on) but will boot (POST) from restart (softboot) everytime....

Recent build was working; now no POST, no beep. I've built quite a few, and this one was working fine for several months - and no recent changes. Suddenly, it won't boot at all. No POST, no beeps, no signal to the monitor. The Power light comes on, the fans...

A1 and applied power, then cleared CMOS, then it booted with successful POST. Added second module in slot B1 and successful boot again. Added third and fourth modules (4 x 2GB) and successfully booted, good POST, entered Setup. Now the problem is that only...

checked when it didn't boot. Very frustrating - wish I had a local friend with an i7 so I could test it out to make sure that it is the CPU that is dead. At this point I'll have to RMA it. I'll post if the new one works or not. I am getting the same thing....