VLAN and Subnet. Archived from groups: comp.dcom.lans.ethernet () Hi! I was wondering that if a host, e.g., a PC or STB or other user multi-media device in an end-user home network is a memebr of multiple VLANs, will it require multiple IP interfaces,...

way to logically separate units of the apartments complex for > security and bandwidth management. VLANS? My CAT switch can do > port-based VLANS, but requires VTP functionality in the router. You do the separation in the switch(es) using asymmetric port-based...

operate only at layer 2; all ports will be in the same subnet no matter what. Managed L3 switches have VLANs; you can specifies which ports belong to which VLAN. Think of VLANs as subnets at the logical level. Creating VLANs mean that to communicate between...

the Win2K DHCP server. Instead, it gets an autoconfig-type address. The WAP, when just an access point, only allows me to specify the IP and subnet mask. When router functions are enabled, I can set WAN IP settings, including IP addr, subnet mask,...

192.168.11.0/24 Subnet-3 : 192.168.12.0/24 All subnet masks : 255.255.255.0 All IP's assigned statically, no DHCP running. VLAN SET UP (SWITCH, VLAN, CONFIG): ----------------------------------------------- MODIFY VLAN 1 (UNTAGGED): Ports 1-24...

VLAN vs subnetting. Archived from groups: comp.dcom.lans.ethernet () Hi All, I am not sure if this is the right forum to ask this question. Please excuse me if so. I would like to know when one should design networks using VLAN vs subnets if one has...

24 subnet? Once I do that, I know I need to setup DHCP relay to our w2k dhcp server or setup on the router. That *seems* simply enough. Once the vlan is on the new subnet, do I have to configure routing to get it on the internet? Please see this thread...

Bridging VLANs on an HP ProCurve 2626. Archived from groups: comp.dcom.lans.ethernet () Hi, I two VLANs serving the same subnet. One VLAN has 802.1Q tagging devices attached to it, the other has untagged devices attached to it. (I can't do this with...

the cluster within a VLAN, sort out a way to send cluster traffic to all attached ports, but then you add a router (or the routing inside your layer 3 switch) to connect that VLAN as a separate subnet to the rest of your network. If you use unicast cluster...

to be doing this. so in otherwords, routing seems to be broken. how do i fix this? finally, i have problems accessing another system on the VPN interface subnet. apparently, the addition of the new nic has taken over the route for that subnet which...