Possible low voltage problem?. Hi all, Quick question: From reading these and other forums it seems that a 5% voltage deviation is the accepted level for a PSU. That comes to 11.4-12.6V on a 12V rail.. I use CPUID HWMonitor to keep an eye on max temps...

tested stable, 63 degree C load (under P95), also my Ram is running at 1333MHz with 8-8-8-20 timing, command rate 1T, voltage 1.64V The problem I got is that when I tried to increase CPU speed over 166, I would have to increase voltage so much to be able...

voltage problems. i just built my sister a computer this weekend, duron 900, msi nforce mobo, 256 meg crucial ddr. the problem im having with it is the power read out for 3.3 volt reads 4 volts, is this a seriouse problem? its a pretty generic power supply....

Voltage problems?. Hi! I bought a new Evga 8800GTX. Everything runs fine, but after istalling Nvidia monitor, i noticed that the voltage was marked red. And it says if its red the card receives too much voltage and may be damaged :( Data: cpu-1,400V memory-1,...

Ntune & Easytune Gigabyte P35-D-Q6 PCI-E voltage problem. Can some one tell me if this is a mobo problem or a videocard problem ? my videocard runs in safe mode and i get a score of 3200 on 3D 2006 XFX...

AGP voltage problem.. Hello, I have an older PC, and the original video card I had was an AGP 9600. Occasionally in games ASUS probe would pop up and show that the 3.3v voltage had dropped to ~3, sometimes even as low as 2.8. I recklessly ignored it until...

8800GTS voltage problems, please help!. Hi guys, I just built my new computer. Specs are as follows: Intel C2D E6400 @ 3.0GHz Gigabyte 965P DS3 OCZ PC-6400 Platinum Rev 2 (1024 x 2) XFX 8800GTS @ 630/950 Silverstone ST65ZF Cooler Master Hyper 48 HSF...

Sipura low ring voltage problem .... Archived from groups: comp.dcom.voice-over-ip () I am having trouble with my Sipura SPA-2000 (through BroadVoice). I am fairly sure that the problem is related to low ring voltage. I have had several problems related...

disclaimers apply! Do NOT try this at home kids. Good luck! even with the heat and voltage problem my system seems to be running incredably stable, i played fear for 3 or 4 hours straight and had no problems whatsoever, im deffently going to clean out the...

Voltage problem. I wasn't sure if I should post this here or in the mobo section. Well the thing is that my +12v was low. Speedfan and MBM were showing that it had 11.19v. Now I have a new PSU and these are the current voltages. Vcore=1.63 +3.3v=3.28...