through LiveVoIP. I run into problems when I try to use the menus with devices which only generate inband DTMF. The simple problem is kphone. Using its G.711 codec and setting "dtmfmode=inband" results in this. Oct 30 16:47:53 WARNING[1149348784]: dsp.c:...

build 1095" for peer 2001 -- Executing Dial("SIP/2000-1a06", "SIP/2001|20") in new stack -- Called 2001 -- SIP/2001-205a is ringing Oct 14 13:26:39 WARNING[6150]: chan_sip.c:681 retrans_pkt: Maximum retries excee ded on call 43458-D1B9-11C3-5BED-DD74319D5BB9...

GA-G33M-S2H mobo. Now that the installation is completed, I want try to enable AHCI and SATA Port0-1 Native Mode, but Windows dies during boot with a blue screen. I tried to install again with AHCI enabled, but I can't find the right drivers to feed Windows...

back from my third disk? Gigabyte P35-D3R Intel Sata controller thanks lol i have a feeling thats copied and pasted from the wiki article... Great guide, but I have one question. If Windows (Vista, in my case) is already installed, can one then...

hard disks, THEN installed Windows. So if you are setting up a new system with AHCI-capable controllers, DO NOT enable it until you have Windows installed and then your motherboard chipset drivers for AHCI installed. Trying to jump the gun and be too advanced...

or if anyone else who has one of these boards notices this. Biggest complaint....if you install a large GPU, like my 8800GTS, it covers the SATA ports. You simply cannot plug or unplug a cable with the GPU installed. It sits down snugly against the cables....

windows,does anyone know why this is happening?thank you Probably because it doesn't load and install the driver, since you run it on IDE mode in BIOS while installing Windows. Try installing Windows with AHCI selected in BIOS, loading AHCI drivers at...

Intel(R) Turbo Boost Tech ...................... [Enabled] CPU Cores Enabled .............................. [All] CPU Multi Threading .............................[Enabled] CPU Enhanced Halt (C1E) ........................ [DISABLED] C3/C6/C7 State Support...

Nvidia SATA controllers before, but Intel controllers just seem to work). Is it set to AHCI or ATA mode in the BIOS? That's an older hard drive, so it may have trouble if you have it set to AHCI mode. Also, is the hard drive being detected in the BIOS? If not,...

I'm not sure how to rectify this. 1) What is AHCI? I don't want RAID. Do I enable AHCI or keep it at IDE? 2) Do I have to reinstall/reimage Win7 after I enable my SATA controllers? 2) After I enable the controllers, should I install the Gigabyte...