Hi so I tried upgrading my Flare X F4-2400C15D-16GFX to Flare X f4-3200c14d-16gfx.
Problem is the ram will only run at 2400mhz in dual channel but will run at 1599 in single channel.
I have tried both sticks in single channel and they run fine.
I have tried all XMP profiles from 2400 up to 3200 and they all fail it is only when I leave it at auto it will boot in dual channel mode.
Both sticks running in dimms A2 and B2. Runs 1599 in single in b2 but only single channel mode.
I am running an Asrock X370 Taichi with BIOS 3.3, I had 4.7 and 4.8 and they both failed to boot also.
My timings were 14-14-14-34 @1.35v as advised by G.Skill.
Can anyone advise what I am doing wrong?
EDIT: Just tried my old 2400 ram and this also fails when trying to use XMP profiles of any speed.
Problem is the ram will only run at 2400mhz in dual channel but will run at 1599 in single channel.
I have tried both sticks in single channel and they run fine.
I have tried all XMP profiles from 2400 up to 3200 and they all fail it is only when I leave it at auto it will boot in dual channel mode.
Both sticks running in dimms A2 and B2. Runs 1599 in single in b2 but only single channel mode.
I am running an Asrock X370 Taichi with BIOS 3.3, I had 4.7 and 4.8 and they both failed to boot also.
My timings were 14-14-14-34 @1.35v as advised by G.Skill.
Can anyone advise what I am doing wrong?
EDIT: Just tried my old 2400 ram and this also fails when trying to use XMP profiles of any speed.