Lucky buyer scores ten Nvidia GTX 1070 GPUs for $100 — nine out of 10 are working after a good bath
Not everyone can be lucky, but it is a great find!
Youtuber Bryan, who runs Tech Yes City, picked ten 'untested' Inno3D GTX 1070 8GB GDDR5 GPUs, likely from a mining farm, which he later confirmed upon personal inspection. The ad was on the Facebook AU marketplace, where the seller was upfront about the condition of these GPUs, stating that it is likely one or two graphics cards are working only via its DVI port- which he also says could be the fault of his PC. Still, these are pretty cheap, and the cards can likely be repaired or salvaged as a donor board. It is a gamble, but for AUD 180 (later reduced to AUD 150), roughly $100, it could be worth it in some form. Bryan said that he has been getting into soldering capacitors on motherboards.
Before Bryan could fire up these graphics cards, Bryan gave them thorough cleaning as running graphics cards in a mining environment tends to pick up a lot of dust. The graphics cards are abused to the point there would be some rust in the components; hence, agitating it is necessary, especially for the video output ports. All the GPUs were dilapidated, and Bryan found it surprising that the seller claimed at least one of the GTX 1070 was working. Irrespective of its outcome, he hoped that these graphics cards were undervolted when mining and would have to undervolt the graphics card.
Once unassembled, dirt and grime can be seen on the PCB and the heatsink. Upon consulting his brother, Bryan used a little vinegar to remove the rust from the heatsink. After giving the PCB and the heatsink a good wash under his ultrasonic cleaner, followed by a rinse, both the components were way cleaner. After cleaning its fans by hand and blow-drying the components, the GPUs were given an application of thermal paste and re-assembled, ready to be tested.
After rescuing from 'Crustation Nation' as Bryan calls it, all the 10 GTX 1070s were tested and checked for stability. Bryan was gobsmacked as nine out of ten GTX 1070s were working just fine, with the last graphic card having a peculiar problem where it wouldn't boot through HDMI or DVI port. Using a DisplayPort adapter to a DVI connector yielded no success. Using the DisplayPort output at first didn't work correctly to the extent that he couldn't get the system with it to boot to Windows. Bryan said he used the heat gun on this GPU's connection ports, hoping it would do the trick, but didn't make any changes.
A quick search on the Facebook marketplace revealed that you could buy a GTX 1070 8GB GDDR5 for 120 AUD, so Bryan was lucky to get nine units working the way they should after a good cleaning and fresh application of a thermal paste. There could be a change for the tenth graphic card to be fixed, maybe if the issue can be localized for Bryan to take care of it.
Getting a graphics card repaired in many countries could be expensive. While getting nine graphics cards, let alone one was an incredible find, it should be noted that not everyone will be lucky enough to get a bunch of graphic cards from a mining farm, as it should be. In such cases, it's a gamble, and it was an excellent one for Bryan only after he gave it a good scrub using a Sonic cleaner, something not necessarily many would have.
It is also a good learning experience for sellers to give the graphic card's PCB a good cleaning and fresh application of thermal paste and pads where needed, allowing them to verify its working condition only to sell it at a reasonable price. In any case, Bryan rescued these graphics cards, giving them a new lease of life away from landfills.
Stay On the Cutting Edge: Get the Tom's Hardware Newsletter
Get Tom's Hardware's best news and in-depth reviews, straight to your inbox.
Roshan Ashraf Shaikh has been in the Indian PC hardware community since the early 2000s and has been building PCs, contributing to many Indian tech forums, & blogs. He operated Hardware BBQ for 11 years and wrote news for eTeknix & TweakTown before joining Tom's Hardware team. Besides tech, he is interested in fighting games, movies, anime, and mechanical watches.
-
punkncat It is funny that the moment I saw the thread title the thought was that someone tuned into Tech Yes City....Reply -
Notton IDK about other people, but I would not pay $100 for a GTX 1070 from 2016, used for an unknown duration/configuration in a crypto farm, needed a bath to get working, and who knows how much life the various parts have left in them.Reply
Although, this also speaks volumes for the new market for 8GB video cards in general. -
circadia
he paid ten dollars for each 1070, not 100.Notton said:IDK about other people, but I would not pay $100 for a GTX 1070 from 2016, used for an unknown duration/configuration in a crypto farm, needed a bath to get working, and who knows how much life the various parts have left in them.
Although, this also speaks volumes for the new market for 8GB video cards in general. -
Misgar I would probably just clean the fans carefully with a brush, make sure they're not jammed solid, blow the dust off the board, then plug it into an old computer. Further tests would show if repasting was necessary. Of course if Bryan wants to resell the boards, I applaud him for taking the time and trouble to clean them thoroughly.Reply
"Bryan used a little vinegar to remove the rust from the heatsink."
I'm intrigued. According to Wiki:
Rust is an iron oxide, a usually reddish-brown oxide formed by the reaction of iron and oxygen in the catalytic presence of water or air moisture.
Was part of the GPU heatsink made from iron?
Most of the heatsinks I've seen are made from Aluminium and Copper, not Iron.
In the case of Copper, the greenish coloured oxide is called Verdigris. When Aluminium oxidizes, it turns white.
Rust is brown, not green or white.
As for using vinegar to remove rust, it's easily available, but I'd reach for my bottle of dilute phosphoric acid, which I use a a flux when soldering some metals. You occasionally get "Flash Rust" forming after using vinegar and phosphoric acid can be used as a rust converter/inhibitor.
Applying a rust converter or inhibitor like phosphoric acid on the rusted surface also helps in preventing flash rusting. It creates a passive layer on the surface that protects it from rust formation.https://www.toolsadvisor.org/how-to-stop-flash-rust-after-vinegar/FAQsWhat causes flash rust after using vinegar as a rust remover?Vinegar contains acetic acid that can breakdown the protective layer on metal surfaces, leaving them vulnerable to rusting. This can lead to flash rusting if left untreated.
How can you prevent flash rust after using vinegar?After using vinegar to remove rust, it’s best to neutralize the surface by washing it with baking soda and water. Then, dry the surface thoroughly and apply a rust converter or inhibitor to prevent flash rust.
Can you use vinegar to remove rust from all types of metals?While vinegar can be effective at removing rust from iron or steel, it may not work as well on rust stains from other types of metals like copper or aluminum.
What is flash rust?Flash rust is the rapid formation of rust on metal surfaces shortly after they have been cleaned or exposed to water. This can occur when the metal is not adequately protected or treated after cleaning.
How long does it take for flash rust to occur?Flash rust can occur within minutes to hours after a metal surface has been cleaned or exposed to water, especially in humid or wet conditions. -
Notton
Uh, I know that?circadia said:he paid ten dollars for each 1070, not 100.
What I meant by that was the repaired cards from a farm, let alone 8yr old ones, aren't worth $100, and the total profit expected from flipping is going to be significantly less than what the article would have you believe. -
Math Geek i don't think the point is to flip them.Reply
he's just someone who enjoys tinkering and saw an opportunity to explore some. i'm sure he was well aware they might all be duds and just wanted to see if he could bring em back to life.
some of us actually enjoy doing such things just for the fun of it. :cool: -
doughillman Uh, is the going price for a mined-up 1070 anything more than about $10 at this point? How is this guy "lucky"?Reply -
punkncat Math Geek said:i don't think the point is to flip them.
he's just someone who enjoys tinkering and saw an opportunity to explore some. i'm sure he was well aware they might all be duds and just wanted to see if he could bring em back to life.
some of us actually enjoy doing such things just for the fun of it. :cool:
Oh no, he is absolutely going to flip them. Tech Yes City is one of my favorite content channels. The market in Australia is so far removed from the US, whole different ball game there. -
newtechldtech
these 1070 will be sold for $50 each in no time.Notton said:Uh, I know that?
What I meant by that was the repaired cards from a farm, let alone 8yr old ones, aren't worth $100, and the total profit expected from flipping is going to be significantly less than what the article would have you believe. -
Ashcanwin
I think he meant if this guy resells them now that they’ve been cleaned. He wouldn’t pay $100.circadia said:he paid ten dollars for each 1070, not 100.