Seasonic Prime Ultra Titanium 1000W PSU Review: Quiet Dominance

Why you can trust Tom's Hardware Our expert reviewers spend hours testing and comparing products and services so you can choose the best for you. Find out more about how we test.

Cross-Load Tests & Infrared Images

Our cross-load tests are described in detail here.

To generate the following charts, we set our loaders to auto mode through our custom-made software before trying more than 25,000 possible load combinations with the +12V, 5V, and 3.3V rails. The load regulation deviations in each of the charts below were calculated by taking the nominal values of the rails (12V, 5V, and 3.3V) as point zero. The ambient temperature was between at 30°C (86°F) to 32°C (89.6°F).

Load Regulation Charts

Efficiency Chart

There is a pretty small region where efficiency exceeds 94%. Otherwise, there's a much larger range where efficiency falls between 92 and 94%.

Ripple Charts

Infrared Images

We applied half-load for 10 minutes with the PSU's top cover and cooling fan removed before taking photos with our modified FLIR E4 camera that delivers 320x240 IR resolution (76,800 pixels).

Temperatures inside the PSU are low thanks to its high efficiency.


MORE: Best Power Supplies


MORE: How We Test Power Supplies


MORE: All Power Supply Content

Contributing Editor

Aris Mpitziopoulos is a Contributing Editor at Tom's Hardware US, covering PSUs.

  • jaber2
    Boy that is cheap
    Reply
  • Nintendork
    I really wish companies focus on 300-550w Titanium PSU's, who the hell uses SLI/CF this days? Market is going multiCCX gpu's in the upcoming years.

    A Ryzen 2700X + Vega56/1070ti systems won't even draw past 375-400w. Most gaming PC's will stay at below 250w. Meanwhile for people who keep their PC 24/7 most of the time in idle, a contained PSU at titanium with 90% efficiency at 10% load is awesome.

    My Bronze Seasonic S12-II 520w seems to be a gem with 82% efficiency at 10% load when most higher grade PSU's (gold/platinum) ignore this since they only need to comply with 85-90% minimum @20% load and then crapify to hell once you reach 15-10% load.
    Reply
  • Armando_0818
    Just an FYI. CISPR 22 is no longer used. It has been updated to CISPR 32.

    Regards
    Reply
  • Aris_Mp
    Thank you! The limits are the same though for the conducted emissions that we measure and in general the products that pass the CISPR22 are likely to pass testing against CIPSR32.

    The CISPR22 was for information technology equipment while CIPSR32 is for multimedia stuff in general.
    Reply
  • zodiacfml
    Would you mind reviewing crypto PSUs from China? I have this Senlifang 2000W with 95 PLUS Gold sticker on it.
    I don't expect such efficiency until one day I plugged it to a system which previously has an 80 Plus Bronze - 650W PSU. The consumption on both PSUs are almost the same!
    Adding to that, I've read somewhere that it is easier to have higher efficiencies on high wattage PSUs which I guess adds more credibility to the Senlifang PSU efficiency claims.
    Reply
  • Aris_Mp
    I don't believe that any of those manufacturers would be willing to send a review sample to me (or to any other PSU reviewer with proper equipment). The majority of them sell overrated stuff using bogus labels. Just be extra careful with those unknown PSU brands promising super high efficiency and wattage.
    Reply