Does Your Storage Controller Affect The Performance Of An SSD?

Features
By ,
published

Results: Access Time And I/O Performance

Access Time

When Samsung's 840 Pro is attached to a Z87 Express-based motherboard, its access time is about three times lower than when we attach it to AMD's A75 FCH. The other 10 controllers, whether integrated into a south bridge or discrete, fall in between.

I/O Performance

When we run the Iometer database benchmark, four controllers from Intel end up on top. AMD's SB950 follows immediately after. Only the 3 Gb/s-capable SB750 trails far behind. The other 3 Gb/s controllers clearly aren't throughput-limited, since they're able to outmaneuver some of the 6 Gb/s options.

Intel's Z77 and Z87 Express chipsets fare really well in the Web server and workstation workloads, though AMD's integrated controllers aren't far behind.

Manuel Masiero
23 Comments Comment from the forums
  • Madn3ss795
    It's clear that Intel won over AMD in this, because 4k read/write and access time is what we care most about nowadays. It's a shame that AMD went for quantity over quality.

    As a side note, when can we see an usb3.0 controller comparison with those new AMD and Intel chipsets?
    Reply
  • SteelCity1981
    I was surprised to see intels 3gbs outpace marvels 6bps controllers in many benchmarks. Just goes to show you that not all SATA controllers are created equal.
    Reply
  • mapesdhs
    The one thing the article didn't say, which it should, is that Marvell controllers
    are garbage. Notice how often the P55 matches or beats one of the Marvell
    6gbit controllers. The PCIe x1 link issue is bad enough, but sometimes even
    having a proper connection doesn't help their performance.

    Also not mentioned is SSD reliability. The only time I've ever had problems
    with an SSD were when it was connected to a Marvell controller (eg. failed
    fw update; move the SSD to an Intel port, the update then works ok).

    Ian.

    Reply
  • slomo4sho
    I would like to see if there is any performance difference when each of the 3rd party controllers are tested on the available platforms.
    Reply
  • jg11
    There is one very significant piece of information that is not included in this article. Which particular ports being used on the controller makes a big difference.

    Most of the embedded chipsets (or external chipsets) carry a multiplexer between SATA and PCI Express. The CPUs accept PCI Express connections, not SATA, so there is a conversion that must be made, which is done by the SATA chipset. Each lane on PCI Express 2.0 supports approximately 8GB/s, and PCI Express 3.0 supports approximately 15 GB/s.

    Here's the problem I have seen in external expansion slots. They connect 4 SATA slots to a single PCI Express 2.0. So potentially, four connected SATA 6 GB/s drives, or 24 GB/s total I/O throughput, is being processed into a single 5 GB/s connection to the CPU. I don't care how good the SATA chipset is at processing and prioritizing I/O data, you are going to have an I/O bottleneck. Even four SATA 3 GB/s drives create a total of 12 GB/s throughput, more than a single PCI Express 2.0 lane can handle. SSDs can approach speeds greater than 3 GB/s, so it is not a theoretical bottleneck, it is a very real limitation.

    So going back to the article. At most, I have seen 4 SATA slots connected to a single PCI Express 2.0 lane. I have seen 6 or 8 connected to either 2 discrete lanes or a 2x lane (or 4x lane when talking about SAS), which carries approximately 10 GB/s of total throughput. So depending on the implementation of the embedded chipset on the motherboard, it may be the PCI Express lanes giving you the throughput limitation and not the SATA chipset. Different ports may be connected to different 1x PCI Express lanes or to a 2x lane, giving you either two discrete paths to the CPU, maximizing throughput, or a larger pipeline to the CPU, which is better than a 1x lane but not nearly as good as discrete pathways.

    I have an external PCI Express controller with a few drives on my main system, and when transferring files from drives on the internal (motherboard) chipset to drives on the connected card, there is a noticeable throughput difference.
    Reply
  • Onus
    I would like to have seen how CPU speed affects these measurements, if at all. As it is, other than to get off a Marvel controller or upgrade from 3Gb/s to 6Gb/s, there doesn't appear to be a whole lot of difference; some, but not enough to write home about (i.e. to suggest an upgrade).
    Reply
  • Shneiky
    I am disappointed that there was no 67 chipset. After all, most of the people are still on Sandy Bridge.
    Reply
  • Lefturn
    Great article guys. I own an 840 pro myself, and I was wondering why the built-in benchmark numbers weren't as high as what was advertised. Now I know.
    Reply
  • ArmedandDangerous
    Looking at the testbed, I see the Intel X-25M G ONE. How the heck did that achieve above 300+MBps doing anyting at all? It's a SATA2.0 device, which is a 3Gbps interface. Your benchmarks are showing 6Gbps scores.
    Reply
  • ronch79
    Sorry guys, I just need to put in some 'constructive criticism'. This article's last paragraph just sounds so stupid and OBVIOUS that it's like reading an old issue of PC Magazine where the authors are a bunch of old fuddy-duddies who say things that are just too obvious. ALL motherboards today come with built-in SATA ports and nobody who has half a brain will buy a separate PCIe SATA controller to run his SSD or mech HDD. NOBODY! Unless that person has (1) run out of southbridge-provided SATA ports, or (2) he has an old board with old SATA 3Gbps ports and thinks a fancy new SATA 6 PCIe card will be a nice upgrade, or (3) he does have less than half a brain and thinks that a separate SATA controller somehow has some secret sauce that's faster than the motherboard SATA ports, or, lastly, (4) he thinks that the ASMedia controller that also came extra with his board is better than what Intel or AMD came up with. Of these four possibilities, 1 and 2 are probably acceptable, 3 and 4 are stupid scenarios.

    No, OF COURSE and OBVIOUSLY you plug devices into the built-in southbridge-connected SATA ports. Anyone who even thinks about installing his own SSD will AUTOMATICALLY do that, not go out and buy a separate SATA controller!
    Reply