Why you can trust Tom's Hardware Our expert reviewers spend hours testing and comparing products and services so you can choose the best for you. Find out more about how we test.
Cross-Load Tests And Infrared Images
To generate the following charts, we set our loaders to auto mode through our custom-made software before trying over a thousand possible load combinations with the +12V, 5V and 3.3V rails. The load regulation deviations in each of the charts below were calculated by taking the nominal values of the rails (12V, 5V and 3.3V) as point zero.
+12V Load Regulation Chart
The deviation compared to the nominal value of this rail, which is exactly 12V according to the ATX spec, is within two percent in the worst case.
5V Load Regulation Chart
3.3V Load Regulation Chart
Efficiency Chart
For the most part, this unit's efficiency falls between 90 and 95 percent, which is excellent, given that we have a 1.6kW PSU on the bench that not only has a huge operating range but also increased energy losses compared to lower-capacity units. Despite this fact, Super Flower managed to extend the high-efficiency region from about 200 to around 1550W. For those who have 230V mains, the voltage efficiency is significantly higher, especially at increased loads.
+12V Ripple Chart
Ripple suppression on the +12V rail is perfect throughout the PSU's entire operating range.
5V Ripple Chart
We see good ripple suppression on the 5V rail, too, since ripple doesn't exceed 20mV in any case.
3.3V Ripple Chart
At 3.3V, ripple suppression isn't as good as on the rest of the rails. Generally speaking, though, and in comparison with the other PSUs in this category, it is good enough.
5VSB Ripple Chart
Ripple suppression isn't as important at 5VSB. But we still want to see low ripple readings. The 1600 P2 doesn't let us down; this rail stays under 20mV of ripple.
Infrared Images
During the end of the cross-load tests, we took some photos of the PSU as it was being tested with our modified FLIR E4 camera that delivers 320x240 IR resolution (76,800 pixels).
Even at normal ambient temperature, the supply gets quite hot after many hours of testing at high loads, which was done to generate the above cross-load graphs. The power cord's temperature reached 50 C, because a lot of Amperes were passing through it. The modular cables also exhibited increased temperatures. These temperatures were safe, though, since the cables delivered high power levels for a prolonged period.
'Idiot-proof' thermal paste applicator to make TIM application easier than ever — X-Apply stencils coming soon
TSMC to go 3D with wafer-sized processors — CoW-SoW technology allows 3D stacking for the world's largest chips
Huawei backs development of HBM memory in China — new consortium aims to sidestep US sanctions
