OSD Setup and Calibration of the PG278Q
The ROG Swift is completely focused on gaming, and as such has a minimal OSD. Fortunately, there are just enough adjustments to dial in color and grayscale properly. We also discovered a couple of other unique features.
The Color menu has Brightness, Contrast, and Color Temp controls. Even though the gamma measured fine in our press sample, a couple of presets to make the tone darker or lighter for specific games would be nice.
Color Temp contains three fixed presets (Normal, Warm, Cool) and a User mode with RGB sliders. They start at their maximums, which is not ideal, but you won’t give up much contrast by calibrating them.
The Image menu has an OD (overdrive) option and the ULMB motion-blur reduction feature. We did all our tests on the OD Normal setting and saw no artifacts at all. ULMB, as already mentioned, improves motion resolution and reduces light output. To see just how much, check out our charts on page ten.
The final menu has language options, OSD position and timeout, signal info, and Light In Motion (a toggle for the red light that rings the monitor’s base). If you turn it on, the light stays lit even when the Swift is turned off. All Reset returns the menu settings to their factory defaults.
Since the PG278Q only has one picture mode, calibration is limited to setting the desired brightness level and choosing a color temperature. The User preset unlocks the RGB sliders, which start at their maximum values. A few clicks to red and green gave us decent grayscale tracking. There are no gamma adjustments. But our tests showed solid results, so they’re not missed. We obtained our benchmark results with ULMB turned off. It’s a variable backlight strobe, so it reduces light output. Again, check out the complete tests on page ten.
|Asus ROG Swift PG278Q Calibration Settings|
|RGB||Red 94, Green 98, Blue 100|