Thermaltake Toughpower DPS G RGB 1250W PSU Review

Why you can trust Tom's Hardware Our expert reviewers spend hours testing and comparing products and services so you can choose the best for you. Find out more about how we test.

Cross-Load Tests And Infrared Images

Our cross-load tests are described in detail here.

To generate the following charts, we set our loaders to auto mode through our custom-made software before trying more than 25,000 possible load combinations with the +12V, 5V and 3.3V rails. The load regulation deviations in each of the charts below were calculated by taking the nominal values of the rails (12V, 5V and 3.3V) as point zero.

Load Regulation Charts

Efficiency Chart

Efficiency is very high; a large part of this chart registers 92%-94%. There's even a small red dot in the middle where efficiency exceeds 94%.

Ripple Charts

Infrared Images

We removed the top cover and applied 660W load for about 12 minutes before taking some photos of the PSU with our modified FLIR E4 camera, which delivers 320x240 IR resolution (76,800 pixels).

The temperature inside the PSU stays low, even though we applied 53% of its maximum-rated capacity load for quite a while with the fan removed. We only noticed high temperatures on a DC-DC converter that handles one of the minor rails. The operating temperatures of the bridge rectifiers, the APFC's components, the primary switchers, and the +12V FETs stay normal. This is a highly efficient Titanium-class power supply, so thermal loads are kept low.

Aris Mpitziopoulos
Contributing Editor

Aris Mpitziopoulos is a contributing editor at Tom's Hardware, covering PSUs.

  • GPUEnthusiast
    I think those cables look straight ugly with three colors like that. In a windowed case, you won't even notice they're sleeved and it will instead look like an old style power supply with the rainbow wires, just really thick. I think they should stick with black and red, or just black. That yellow is faded too much and looks like it's for a banana themed build.
    Reply
  • g-unit1111
    Maybe it's me but I fail to grasp how an RGB ring on a PSU adds to it. Especially since most cases have bottom-mounted PSUs these days.
    Reply
  • jimmysmitty
    18420891 said:
    Maybe it's me but I fail to grasp how an RGB ring on a PSU adds to it. Especially since most cases have bottom-mounted PSUs these days.

    It's all about them ground effects brah!!!!!

    I agree though. Unless you have a very open bottom, most do not since most have a dust filter, it wont really show. I would expect a LED logo instead.
    Reply
  • Nergo Pthycc
    Gimme more LED's and maybe some rhinestones that glow and rotate!
    Reply
  • turkey3_scratch
    This is a really great power supply! The transient response performance is top-notch. I really like it. The only thing I wish is for it to be a multirail design.
    Reply
  • basroil
    Almost something I could recommend, if not for that horrible double line frequency oscillation in the 12V. I would have expected a digitally controlled system to be able to remove simple harmonics like that. Perhaps their controller algorithm isn't all that great?
    Reply
  • powernod
    I was anxiously expecting this review due to CWT's new CST platform.
    Just like Aris said at the end of his review, i'm expecting to see how the smaller wattage models will perform.
    The 1250 watt model seems like an excellent unit, and the only thing i disliked is the small output from the smaller rails ( 20A @5V &3.3V / 15A @5VSB ).
    P.S. Once again, an excellent review from Aris!!
    Reply
  • ralanahm
    So with 104 amps on 12volts can you jump start your car?
    Reply
  • Sunderas
    At this price I would never go for it.
    Reply