Riotoro Onyx 650W PSU Review

Early Verdict

It is quite odd to meet such a modern platform in this category, however GW didn't fully utlize it so the efficiency difference between the Onyx 650 and its main competitor, the Corsair CX650M, isn't so large. With a small number of upgrades the Onyx 650 could be much better, but even at its current state it offers pretty much for its price tag.

Pros

  • +

    Full power at 46°C

  • +

    Build quality

  • +

    Affordable

  • +

    Japanese electrolytic caps

  • +

    Load regulation (+12V)

  • +

    Accurate Power Ok signal

  • +

    Semi-modular with only two fixed cables

  • +

    Option for 4x PCIe connectors

  • +

    Full protections set

Cons

  • -

    Ripple suppression could be better

  • -

    Hold-up time

  • -

    Not so silent

  • -

    OTP is set high

  • -

    Sleeve bearing fan

Why you can trust Tom's Hardware Our expert reviewers spend hours testing and comparing products and services so you can choose the best for you. Find out more about how we test.

Features & Specifications

Riotoro is a new company trying to enter the tough PSU market where big brands dominate. We already reviewed Riotoro's Enigma 850 and determined that it's essentially a clone of Corsair's CS850M, since both units are based on the same Great Wall platform. However, this company has a second family in its portfolio; the mainstream Onyx line-up consists of two members with 650W and 750W capacities. The lower-level Onyx power supplies also employ a Great Wall platform. It isn't as efficient, but it does cost less.

Today we're reviewing the 650W Onyx model, pitting it against popular competitors in this category like Corsair's CX650M. Since we don't have many direct comparisons in our database, we're also including several mid-range and high-end products in order to illustrate the differences between mainstream PSUs and pricier alternatives.

Again, the Onyx 650 is based on a GW platform that's 80 PLUS Bronze-certified. Cybenetics also certified this PSU, and it carries the ETA-A- and LAMBDA-S+ badges.

It sports a semi-modular design with just two native cables. And because of its low efficiency, Riotoro doesn't expose a semi-passive mode. This is a good thing, as increased thermal loads could be catastrophic for reliability over time. While a $70 price tag is certainly nice, the PR-BP0650-SM has to do battle with compelling options from Corsair and EVGA.

Once we gets into this PSU's guts, we'll know more about its expected longevity. When we reviewed the Enigma 850, we didn't like that its bulk cap was only rated at 85°C. Thankfully, Riotoro's Onyx 650 is blessed with high-quality bulk caps. Of course, it looks weird that the higher-end model uses lower-quality bulk caps than the entry-level product. Apparently, someone over at Riotoro wasn't paying close enough attention to the specs.

Specifications

The maximum operating temperature at which Riotoro's PR-BP0650-SM can deliver its full power continuously is limited to 40°C, even though the ATX spec recommends 50°C. In any case, we don't believe that there are many power supplies out there able to truly satisfy this recommendation for extended periods of time. They might be alright serving up full power for 10 or 20 minutes at 50°C, but for 24/7 operation under full load at the same temperature, a PSU has to be specially designed with components resilient to heat and a highly capable fan.

Power Specifications

Swipe to scroll horizontally
Rail3.3V5V12V5VSB-12V
Max. PowerAmps25255430.8
Watts130650159.6
Total Max. Power (W)650

The minor rails are quite strong, reminding us of previous-generation PSUs. Riotoro also arms its PR-BP0650-SM with a capable +12V rail able to output up to 54A. Finally, the 5VSB rail has enough capacity for a modern system.

Cables & Connectors

Swipe to scroll horizontally
Native Cables
DescriptionCable CountConnector Count (Total)Gauge
ATX connector 20+4 pin (550mm)1118-20AWG
4+4 pin EPS12V (620mm)1118AWG
Modular Cables
6+2 pin PCIe (550mm+120mm) 1218AWG
SATA (450mm+110mm+110mm)2618AWG
Four-pin Molex (450mm+120mm+120mm)1318AWG
FDD Adapter (+100mm)1120AWG

Only the necessary cables are native: the ones hosting the 24-pin ATX and EPS connectors. Given the mainstream category that this PSU belongs to, we didn't expect more than a couple of PCIe connectors or two EPS cables. However, if you want to add more connectors, there is an available eight-pin socket on the unit's modular panel that can accommodate an extra EPS or PCIe cable. What we don't know is whether Riotoro plans to sell extra EPS and PCIe cables separately.

Power Distribution

Since this PSU features a single +12V rail, we do not have anything to say about its power distribution.


MORE: Best Power Supplies


MORE: How We Test Power Supplies


MORE: All Power Supply Content

Contributing Editor

Aris Mpitziopoulos is a Contributing Editor at Tom's Hardware US, covering PSUs.

  • turkey3_scratch
    I don't think it's so much the aggressiveness of the fan that contributes to the noise rather than the fact that it's just a noisy fan. There are many other fans that could be spinning at equal RPM and be much quieter while providing the same amount of cooling.
    Then again, the noise should not be too severe of a deal in a computer case with other fans (such as case fans at 100% always) contributing more significantly to the net noise.

    Edit: Nevermind, dope move by me. I didn't realize the y axis started at 1400RPM, yep, that fan RPM is very high indeed.
    Reply
  • Ne0Wolf7
    20135612 said:
    I don't think it's so much the aggressiveness of the fan that contributes to the noise rather than the fact that it's just a noisy fan. There are many other fans that could be spinning at equal RPM and be much quieter while providing the same amount of cooling.

    Then again, the noise should not be too severe of a deal in a computer case with other fans (such as case fans at 100% always) contributing more significantly to the net noise.

    I agree, especially when you're like me and have six of them because you were obsessed with filling all of the fan slots on your first build (lol). When the noise finally got to me, I got creative with my intake/ output configuration, and set my PSU to ECO mode (which is no fan). The PSU started roasting, so I rebooted with the fan going and noticed no noise difference whatsoever and the PSU was much cooler (then again, my case fans are sleeve bearing, but still).
    Reply
  • turkey3_scratch
    20135670 said:
    20135612 said:
    I don't think it's so much the aggressiveness of the fan that contributes to the noise rather than the fact that it's just a noisy fan. There are many other fans that could be spinning at equal RPM and be much quieter while providing the same amount of cooling.

    Then again, the noise should not be too severe of a deal in a computer case with other fans (such as case fans at 100% always) contributing more significantly to the net noise.

    I agree, especially when you're like me and have six of them because you were obsessed with filling all of the fan slots on your first build (lol). When the noise finally got to me, I got creative with my intake/ output configuration, and set my PSU to ECO mode (which is no fan). The PSU started roasting, so I rebooted with the fan going and noticed no noise difference whatsoever and the PSU was much cooler (then again, my case fans are sleeve bearing, but still).

    I have a build with like 6 fans that gets noisy because the motherboard only supports so many fans, so I have to plug them into the PSU. But I also have a second build that is dead silent with some Noctuas, and that's the type of build I would want a very silent or at least semi-passive PSU in.
    Reply
  • Ne0Wolf7
    20135678 said:
    20135670 said:
    20135612 said:
    I don't think it's so much the aggressiveness of the fan that contributes to the noise rather than the fact that it's just a noisy fan. There are many other fans that could be spinning at equal RPM and be much quieter while providing the same amount of cooling.

    Then again, the noise should not be too severe of a deal in a computer case with other fans (such as case fans at 100% always) contributing more significantly to the net noise.

    I agree, especially when you're like me and have six of them because you were obsessed with filling all of the fan slots on your first build (lol). When the noise finally got to me, I got creative with my intake/ output configuration, and set my PSU to ECO mode (which is no fan). The PSU started roasting, so I rebooted with the fan going and noticed no noise difference whatsoever and the PSU was much cooler (then again, my case fans are sleeve bearing, but still).

    I have a build with like 6 fans that gets noisy because the motherboard only supports so many fans, so I have to plug them into the PSU. But I also have a second build that is dead silent with some Noctuas, and that's the type of build I would want a very silent or at least semi-passive PSU in.
    My ATX motherboard only has two fan headers, not sure who was in charge there, haha, but I bought two three way splitters so I could control the speeds. My side panel has two fan slots, and I can only use one of them because the CPU cooler, so I just have this lovely outlet for sound... Its really a blessing too beacsue I have two GPUs so one can never be tarved for air too much but still. A new case and fans are in my future somewhere.
    Reply
  • takeshi7
    Can you review the Rosewill Hive 750W? I got one on sale for $60 recently and there aren't any recent reviews for it, and not from any that are as in depth as Tom's Hardware.
    Reply
  • James Mason
    @takeshi7, there aren't new reviews for it because it isn't a new PSU.
    Reply
  • takeshi7
    20143641 said:
    @takeshi7, there aren't new reviews for it because it isn't a new PSU.
    It's still relevant though. Especially because it's cheaper, more powerful, and has the same 80 Plus rating as this Riotoro unit.
    Reply
  • turkey3_scratch
    20144799 said:
    20143641 said:
    @takeshi7, there aren't new reviews for it because it isn't a new PSU.
    It's still relevant though. Especially because it's cheaper, more powerful, and has the same 80 Plus rating as this Riotoro unit.

    "More powerful" can be interpreted many ways. What do you mean by that?
    Reply
  • takeshi7
    20144830 said:
    20144799 said:
    20143641 said:
    @takeshi7, there aren't new reviews for it because it isn't a new PSU.
    It's still relevant though. Especially because it's cheaper, more powerful, and has the same 80 Plus rating as this Riotoro unit.

    "More powerful" can be interpreted many ways. What do you mean by that?
    I mean 750W > 650W.
    Reply
  • turkey3_scratch
    20144901 said:
    20144830 said:
    20144799 said:
    20143641 said:
    @takeshi7, there aren't new reviews for it because it isn't a new PSU.
    It's still relevant though. Especially because it's cheaper, more powerful, and has the same 80 Plus rating as this Riotoro unit.

    "More powerful" can be interpreted many ways. What do you mean by that?
    I mean 750W > 650W.

    Eh, doesn't really mean much of anything if you ask me. It's just what they decided to rate it at. I don't think we'll ever see a Rosewill Hive review. They're older and newer units get reviewed instead.

    A high quality lower wattage power supply can be more powerful than a lesser quality higher wattage power supply.
    Reply