The next step is installing the holding plates, together with the tracks, in the rack. Since one server, like the MSI model used, weighs about 10 kg, you should use at least two screws per side, in front and in back. While simple (light) components such as a switch are screwed on either in front or in back, computers, USVs and similar heavy devices must always be screwed on in front and in back - the rack has limited stiffness and, as with passenger cars, even the most expensive models can buckle.
Be careful not to accidentally fasten the tracks on the rack server (they are higher and contain rollers or ball bearings to aid in pulling it out). If you have done that, you will know by the fact that the server will no longer fit into the 19" rack.
Correct installation: The support rails on the rack server, the tracks are screwed together with both holding plates. This construct now has to fit exactly into the rack server so it can be screwed in front and in back.
Patrick Schmid was the editor-in-chief for Tom's Hardware from 2005 to 2006. He wrote numerous articles on a wide range of hardware topics, including storage, CPUs, and system builds.
