Inwin’s mid-tower Gundam has a large front door equipped with several illumination effects, which also covers the drive slots behind it. The door mounts are somewhat wonky, and the front door is made out of cheap plastic, but Inwin has put a lot of thought into the interior. Many system fans come pre-installed. In addition to the common ones on the front and back of the case, the Gundam has two additional fans installed so that they blow toward the motherboard and the graphics cards. These fans can be folded down to make hardware installation easier.
Although the interior is tight, there is enough room for ATX and µATX hardware, and long graphics cards fit into the steel case without a problem. The mounting cage for the hard drives is rotated by 90 degrees, which simplifies installation and wiring of the hard drives. The 3.5 inch drives are mounted onto two rails that support and decouple the drives from the case.
Same price range looks better and PSU at the bottom, i like that.
You could set these case up with a Q6600 @ 3Ghz, HD 4870 512Mb and a 650 watt PSU (with stock coolers) and loop 3Dmark06/Vantage for an hour and see if the cases can keep the PC cool enough for that long.
Side intake doesn't have a Dust filter. I had to use that fan as an exhaust until I can order one for it, which means that the case wont have positive airflow until then.
Its really heavy. This case weighs more then my Lian Li full tower case.
It doesn't have a removable Motherboard tray.
One thing that was well thought out was the 3 fans that were not included. While this sounds like a draw back, it isn't. The 3 optional fans that are availible are the 3 most visible fans in the case. Which means that you can customize the color of LED fans you want in it.
I used 3 green antec led 120 mm fans in this case and the air flow is phenomenal.
However having owned the Lian Li B25 I disagree with your comments regarding complexity of installation of the hard drives. Having only built one other system I can say that it takes perhaps 30 sec more than normal to figure out what to do. Also I would have liked to see more details about noise regarding all cases. i can't say for the other but the B25 had sound dampening foam on the front door and on the top cover, the side panels were hollowed out further dampening the noise, the hard drives were connected using rubber (grommets I believe) and there were additional anti vibration features (cant remember) and the feet of the case also used rubber.
1) You could've made a few pictures of the packaging. Cases are things your visitors can see, and you'd want them to be transported to you without taking any, visible or otherwise, damage. Silverstone do an outstanding job at this, and so does antec, but I don't think zalman or thermaltake would care much for the packaging quality (they care about flash stuff, not quality stuff after all). Also I'd have liked a list of noise levels for the cases.
Perhaps you can make another roundup, without limiting yourself to a specific case size and color, of potential gamer cases. And at the end of the roundup make a comparison list with external dimentions, motherboard orientation, weight and noise levels. I'm still using an old thermaltake lanfire chassis for a lan gamer, cause though it's ugly, it's very very light (3kg) and rather well built.
On another note - does anyone know if it is possible to only buy the side panel for that aerocool chassis ? I'd like to built such a door into a new top cover for my custom desktop system ...
Not sure why you would base a recommendation on this information however.
Throw a couple overclocked 4850s and an overclocked C2D in those cases and measure the various temps and get a decibel reading from a fixed point. Those are the things I should know before buying a case.
Some recommendation can be at use for many folks.
On a side note, I think coolermaster may not be represented because they didn't send in any case in time - it's entirely possible they were asked to take part.