NZXT N7 B550 Review: NZXT Meets AMD

NZXT delivers its first B550 motherboard for AMD Ryzen.

NZXT N7 B550
Editor's Choice
(Image credit: © Tom's Hardware)

Why you can trust Tom's Hardware Our expert reviewers spend hours testing and comparing products and services so you can choose the best for you. Find out more about how we test.

Our standard benchmarks and power tests are performed using the CPU’s stock frequencies (including stock Thermal Velocity Boost), with all power-saving features enabled. Optimized defaults are set in the BIOS and the memory set using the XMP profiles. For this baseline testing, Windows is set to High Performance before we switch over to Balanced during power testing, so the PC idles appropriately.

Synthetic Benchmarks

Joe Shields
Staff Writer, Components

Joe Shields is a staff writer at Tom’s Hardware. He reviews motherboards and PC components.

  • Co BIY
    With this much shroud why do I need a case ?

    Both NZXT boards have been released at the same price point.

    Are intel boards still more expensive in general ? or has that gone away now that AMD CPUs are in the lead ?

    Do we need to rethink the assumption that choosing intel means a more expensive motherboard ?
    Reply
  • w_o_t_q
    strange choice top notch mb on B550, need x570 and drop 2.5gb lan or go to 10gb. a 2.5 g lan equipment is as expensive as 10gb so nobody will bother with it.
    Reply
  • coolestcarl
    While I like the look a lot, I do not think this board would have longevity. Heat is the enemy of electronics and I wonder if this board would fail sooner than other similar non shrouded boards. All that heat buildup would be trapped under those shrouds and have a higher equilibrium temperature since there is no passive airflow from the nearby components to cool them off. Even in an air-conditioned room, trapped air would get quite a bit warm (even if it takes longer to initially heat up).
    Reply
  • digitalgriffin
    w_o_t_q said:
    strange choice top notch mb on B550, need x570 and drop 2.5gb lan or go to 10gb. a 2.5 g lan equipment is as expensive as 10gb so nobody will bother with it.

    While I understand your sentiment, 10Gb has some high requirements. Power requirements are extreme for the signaling, and it runs hot with cat 6/7 ethernet. Unless you do your cabling properly, you're going to fall back on speed. A lot of cabling online labeled Cat 6/7 is junk. And there's only a very few select 10Gb switches that are reasonably priced (ie: Microtik) None of the cheap ones support SFP/SIP so you can't mix and match
    Reply
  • HTMLSpinnr
    w_o_t_q said:
    strange choice top notch mb on B550, need x570 and drop 2.5gb lan or go to 10gb. a 2.5 g lan equipment is as expensive as 10gb so nobody will bother with it.

    For homes that are pre-wired w/ Cat5e, 2.5G is all we can support w/o rewiring w/ Cat6A or only supporting 10G in a single room w/ 1G, bonding, or 2.5G uplinks to your wiring panel.
    Reply
  • w_o_t_q
    Cat6 is cheap and if length of cable did not exceed 70 m will work with the 10G
    Reply