Why you can trust Tom's Hardware
PBO Performance and maximum noise levels
We’re going to start this review’s benchmark section by focusing on a traditional maximum performance test, with the CPU cooler’s fans allowed to reach their fastest speeds, for the best cooling possible.
Turning on PBO allows AMD’s Ryzen 9 9950X3D to stretch its legs and consume over 260W. Enabling PBO allows for high power consumption and heat output. When using MSI’s X870E Carbon Wifi motherboard, the CPU will reach its TJ Max (peak temperature) of 95 degrees C (203 F) and thermally throttle, to some extent, with most coolers. When this throttling occurs, I’ve measured the average power consumption to determine performance.
I’ve highlighted the performance of the MEG CoreLiquid E15, the P22, and the prototype P22 to demonstrate how MSI has been continuously improving the thermal performance of its AIOs. The MEG E15 has the second-best results in our current test bench, averaging 62 degrees Celsius over ambient (84 C). Out of curiosity, I also tested the thermal performance to see how better temperatures might perform with an open case – and surprisingly, there was only a single degree’s difference.
The maximum noise levels of this cooler are on the louder end, measuring 48 dBA. But to my ears at least, the the pitch of the cooler’s fans is soft, which makes the cooler feel quieter than how it measures.
200W thermal benchmarks
For the next thermal test, I leave the motherboard settings at their defaults, which results in a power limit of 200W when running Cinebench R23.
Thermal results in this scenario were similar to our first test, with MSI’s E15 being a top performer, holding the third-best results, averaging 47.1 C over ambient (69.1 C).
150W + GPU thermal results
Our next test runs Cinebench on the CPU with a 150W power limit, while also running Furmark on MSI’s RTX 4070 Ti Super Ventus 3x OC. This causes the GPU to consume ~295W of power. This test is designed to emulate the thermals of games, which stress both the CPU and GPU.
Get Tom's Hardware's best news and in-depth reviews, straight to your inbox.
MSI’s E15 AIO once again performs well here, with our second-place result when testing in our Tryx FLOVA F50 test bench. Out of curiosity, I also tested this AIO in an open case, which resulted in an additional thermal improvement of 1.8 C.
Noise levels in this scenario were moderate, registering at 40.9 dBA with our Pyle PSP25 sound meter.
Noise-normalized testing
Most testing is performed with the cooler tied to the default fan curve of our MSI X870E Carbon motherboard, but some of y’all prefer to see tests when the noise levels of coolers are equalized. This is especially important to those of you who prefer silent computers. This next test has the CPU cooler noise-normalized to 38.9 dBA, with PBO enabled for the Ryzen 9 9950X3D CPU.
This test is especially difficult, because in addition to the reduced noise from the CPU cooler, our current test bench’s system fans are configured to run extremely silently, below the floor of the noise meter I use to measure dBA.
The results here are simply excellent. MSI’s E15 is one of the few AIOs on the market capable of keeping the CPU under TJ Max with PBO enabled in our current test bench, even when the noise levels of the fans are limited.
Karhu DDR5 RAM thermals testing
Your CPU cooler does not operate in isolation. It has an impact on not just your CPU’s temperatures, but also the other components in your build, like your RAM and GPU. To that end, I’ve run the Karhu RAM stress test. This places a load of ~153W on the CPU and ensures system RAM (DDR5 in my case) is fully stable. In this type of scenario, most AIOs tend to produce worse results than air coolers.
DDR5 temperatures in this test were good, the best of any AIO, save those incorporating VRM or RAM fans.
Conclusion
With a hefty $399 price, this AIO is strictly for users who don’t care much about build budgets. The stunning black-and-gold aesthetic reflects that luxury status, and the included 6.7-inch screen and preset animations are stunning. Thermal performance is also among the best AIOs on the market, so the cooler isn’t all about style over substance.
But of course, with the ongoing inflated prices of RAM, storage, and GPUs, most of us aren’t likely to seriously consider spending nearly $400 on a cooler. If you’re looking for a more budget-minded alternative, I’d encourage you to check out Arctic’s Liquid Freezer III Pro instead.
Albert Thomas is a contributor for Tom’s Hardware, primarily covering CPU cooling reviews.
-
richardvday Can I get it without the 6.7" screen because all I care about is the cooling. Class leading performance without the swag would be great.Reply -
vinay2070 I have lost all interest in this hobby of PC building after all these price explosion drama.Reply -
thestryker Reply
Unless they get pushed back towards the end of the year a wider range of Asetek AIOs with 30mm radiators should be available. This one is the current version of those which have only been used in really expensive put all the bling in AIOs.richardvday said:Can I get it without the 6.7" screen because all I care about is the cooling. Class leading performance without the swag would be great. -
Albert.Thomas Reply
I would imagine that MSI has something similar in the worksrichardvday said:Can I get it without the 6.7" screen because all I care about is the cooling. Class leading performance without the swag would be great.