Haswell And Richland Memory Scaling: Picking A 16 GB DDR3 Kit

Round-ups
By
published

Graphics workloads love fast memory. But how much difference can a desktop-oriented kit have on gaming performance with Intel's HD Graphics 4600 or AMD's Radeon HD 8670D? We test six 16 GB kits, two all the way up to DDR3-2400 to find out.

Mushkin Redline Ridgeback DDR3-2133

While its competition on the previous page goes cheap in the interest of improving value, Mushkin takes the other path with its 16 GB Redline Ridgeback 997121R kit. Each 8 GB module is rated at low CAS 9 timings and a high DDR3-2133 data rate.

Ridgeback DDR3-2133 boots at DDR3-1600 CAS 11, and is easily configurable to DDR3-2133 CAS 9 on most enthusiast-market motherboards by selecting its corresponding XMP profile. That selection also raises memory voltage by 10%.

Most enthusiast-class AMD motherboards have firmware workarounds to support this Intel-based memory configuration tool, though the few motherboards that don’t support XMP can reach these settings via manual configuration, too.

Save that receipt! Though we’ve never had any problems, Mushkin’s lifetime warranty policy is officially limited to the original purchaser.

Thomas Soderstrom
Thomas Soderstrom
Thomas Soderstrom is a Senior Staff Editor at Tom's Hardware US. He tests and reviews cases, cooling, memory and motherboards.
56 Comments Comment from the forums
  • Someone Somewhere
    What about 8GB? That's still a good option for most gamers.
    Reply
  • DjEaZy
    ... GPU 4.T.W.!!!
    Reply
  • Novuake
    Its a shame the AMD memory controller is so lacking, it matters very little for FX series, but here its a real bummer.

    Anyway, I am reasonably sure you could tighten the timings on the Ripjaws considerably, if this is the case with this specific kit, there is NO reason to get the Mushkins...
    Reply
  • Jarmo
    8GB of fast&expensive memory vs 16GB of the cheap stuff?
    Reply
  • CommentariesAnd More
    IMO 4GB and 8GB is what most APU Gaming Rigs have. Those looking for an APU for Gaming probably would love results with similar kits. But still we would love these results for like a baseline. Also , the Elite FTW in my next APU build/proposal :D
    Reply
  • yannigr
    You did it again. Another "let's make Intel looks better than it is" article.

    How can we give an advantage or two to Intel?
    Let's overclock both cpus. So Intel is getting 1GHz extra from it's default frequency while AMD only gets 400MHz. Then we call this fair.
    Let's lower the resolution and graphics. That way the benchmarks will be less gpu intensive and Intel's much better cpu will make things look more even.
    Not to mention the instability problems with AMD and 2400MHz memory, the problem reaching 4.5GHz. We all know that AMD is unstable and hot. Nice job. You are pros in what you are doing. But off course you where just testing memory here. Yeah right. You lowered the resolution even lower than 1366X768 which is the resolution for hdready displays. I guess lowering the resolution and overclocking was necessary so that Intel gpu can reach 30fps in all tests. Nice work.
    Next time try 800X600 and overclock with LN2.
    Reply
  • 4Ryan6
    Scuttlebutt says that AMD’s A10-6800K reaches 4.5 GHz without much effort, but our sample needed 1.425 V to achieve complete stability. It would easily run 4.4 GHz at 1.30 V, so perhaps 4.5 GHz wasn’t a good target? The problem with 4.4 GHz was that we didn’t want to give the firm a frequency handicap in an article that includes Intel. Our Core i7-4770K was easily running 4.5 GHz at 1.250 V maximum, and we began testing before AMD's sample arrived. And so the test began with the Intel processor at 4.50 GHz, secure in the knowledge that both CPUs would support DDR3-2400 via overclocking. Two of the kits were DDR3-2400-rated. And one of the kits would even run at DDR3-2666.

    Thomas, I know it would have involved more work, but wouldn't the right thing to do have been to reset the overclock target to 4.4ghz?

    You'd have been in safer territory not to have overclocked at all, if the overclock was not the same for each testing.

    Additionally for the record, the very reason some of these overclockers are experiencing such high heat levels are they're overclocking the CPUs memory controller from the very beginning of their overclocking, by attempting to run memory past the design specifications of the CPU right out of the box, that may have been partly the reason you couldn't get past 4.4ghz with acceptable voltage with the A10-6800K.

    These memory manufacturers never claimed their memory could be run at higher multiplier overclock levels as they were only tested, and supposedly guaranteed at the stock CPU speed capabilities at the factory, they never guaranteed they would run stably at 45x or beyond, multiplier ranges in the first place.

    I have yet to see the first memory claim that BrandX not only can run 2400mhz but can run it at a 50x multiplier for Intel or 25x for AMD, to reach 5.0ghz or for that matter 45x or 22.5x for your 4.5ghz target.

    So actually just because you can push the memory to make these tests doesn't mean that running memory speeds way past the CPUs memory controllers design specifications is a safe 24/7 run solution to advise others is seemingly OK, but that is exactly what a lot of users take away from these type of tests.

    Just because someone can, doesn't necessarily mean they should, for the longevity of their hardware, isn't THGs responsibility on a higher level than that?

    Reply
  • de5_Roy
    woulda liked to see how these kits would perform on a desktop intel hd5000/5100/5200 sku. shame on intel for not making those available on desktop! hd4600 blows!
    Reply
  • Novuake
    11546494 said:
    woulda liked to see how these kits would perform on a desktop intel hd5000/5100/5200 sku. shame on intel for not making those available on desktop! hd4600 blows!

    I almost think Nvidia and Intel had some nice discussions and deals to keep Iris out of the desktop.
    Just a hunch...
    Reply
  • Reynod
    Nice work crashman ... good to see they still have you chained to the test bench out the back.

    I hope they are feeding you buddy and letting you out once in a while !!

    Its time they let you loose on another serious overclocking campaign too.

    Chris ... get this man a big can of liquid nitrogen, 2 cartons of coke, a box of mars bars and a mobile hot dog vendor for the day ... time to reward crash.

    :)
    Reply