PSU Roundup: Performance, Price, Efficiency
Efficiency
The Dragon Force’s efficiency is very high relative to its price. At mid-load, the power supply has an excellent efficiency of almost 88 percent. This drops to 84 percent at maximum load, but even under low load the DF-530GT gets a good result of 85.5 percent.
The Dragon Force also does well in the Low-Power PC Test. Its efficiency drops to 76 percent at a 35-watt load, but that’s still extremely high compared with competitors.
In standby mode without load, we measured 1.14 watts out of the socket. Here, some competitors consume significantly less. At standby load it consumes about 4.86 watts, an efficiency of 51 percent. At this level, the power supply is in the middle of the pack.
Dragon Force DF-530GT
Straightforward power supply without special features for an inexpensive price.
- Positives
- Negatives
- Very low price
- No cable managementShort cables with few sockets
Stay On the Cutting Edge: Get the Tom's Hardware Newsletter
Get Tom's Hardware's best news and in-depth reviews, straight to your inbox.
-
falchard That coolermaster PSU is nice that its cables are thin since its really annoying to have those stiff cables fill a small case. However, I wonder about its interference. That insulation and mesh is there for a reason, to prevent discharge and electrical interference of other parts.Reply
Also I can see the reason why a person wouldn't want a CPU/ATX connector on a 700w power supply. If they had an excessively power draining system like a Quad/Tri GPU with modern high end cards it will waste alot of power and using 2 lower watt power supplies is cheaper then getting 1 high watt one. -
dirtmountain Nice fluff piece. I sure wouldn't use any of these recommendations over jonnygurus or hardwaresecrets sites though.Reply -
optik Just bought myself Zalman's ZM-750HP with cable management and heatpipe cooling.. Cost only 131 euros.. When I saw the article's header I hoped to see it being reviewed, but no such luck. Would've been nice to see how the Zalman's offerings would've fared against others.. The productline ranges from 360Watts to full 1000Watt PSU's so plenty to choose from..Reply -
Proximon Without voltage ripple and heat tests you can't properly evaluate a power supply. At least readers can use this as a starting point for further research.Reply -
chookman Heat is generally relative to efficiency , due the fact that the more energy lost the more heat generated.Reply
Ill agree with the ripple tests too, yeh great we might have a power supply that is efficient at 100% but what if the 12v rails are hovering outside of spec...? Its a nothing review really. -
jt1 falchardThat coolermaster PSU is nice that its cables are thin since its really annoying to have those stiff cables fill a small case. However, I wonder about its interference. That insulation and mesh is there for a reason, to prevent discharge and electrical interference of other parts.Reply
What manufacturers use insulation and mesh that block interference? The insulation on the wires of my PSUs is standard insulation, the mesh is plastic and there strictly to hold the wires in place and prevent the inside of a computer case from becoming a birds nest of wires.
If there are manufacturers that use materials to block interferences, I'd like like to look into their products as it sounds interesting but I'd like to hear from someone actually in the know as to if it would make any difference or not.
-
pcfxer Interference on a power supply is negligible. The power runs, voltages and current are of little concern for interference. IF you want to be truly theoretical it would make a "difference".Reply
When I studied power engineering one would need a ton of voltage or current to be 'eligible' for most electrical phenomena to occur - theoretically.